[N8VEM-S100:7700] S-100 Edge Footprint

[Bob Bell]

S-100 gurus - especially those who use KiCAD:



I have been unsuccessful at locating a S-100 card edge footprint in the
KiCAD (v4) built-in library. Do you have one you would share with me? As
this is a rather critical part on the board, it would be great to find one
that has been used successfully.



Thanks for your help.



Bob Bell

[monahanz]

See if these work Bob, otherewise I will look into it more.
John

Post by Bob Bell
I have been unsuccessful at locating a S-100 card edge footprint in the
KiCAD (v4) built-in library. Do you have one you would share with me? As
this is a rather critical part on the board, it would be great to find one
that has been used successfully.
Thanks for your help.
Bob Bell

[Bob Bell]

John,

I imported this into the Footprint Editor successfully.

It says “S-100 Bus Card Edge Male”, but there are only 62 pins (edge fingers).

Am I expected to do something to it to make it work as 100 pins?



Thanks.



Bob Bell





From: n8vem-***@googlegroups.com [mailto:n8vem-***@googlegroups.com] On Behalf Of monahanz
Sent: Thursday, October 01, 2015 8:23 AM
To: N8VEM-S100
Subject: [N8VEM-S100:7702] Re: S-100 Edge Footprint



See if these work Bob, otherewise I will look into it more.

John



On Wednesday, September 30, 2015 at 6:16:36 PM UTC-7, Bob Bell wrote:

S-100 gurus – especially those who use KiCAD:



I have been unsuccessful at locating a S-100 card edge footprint in the KiCAD (v4) built-in library. Do you have one you would share with me? As this is a rather critical part on the board, it would be great to find one that has been used successfully.



Thanks for your help.



Bob Bell

[Bob Bell]

Oh, and this footprint has the pins on a 0.1” center, while S-100 is 0.125”.

Hope you have another that is closer to S-100.



Thanks.



Bob Bell





From: n8vem-***@googlegroups.com [mailto:n8vem-***@googlegroups.com] On Behalf Of monahanz
Sent: Thursday, October 01, 2015 8:23 AM
To: N8VEM-S100
Subject: [N8VEM-S100:7702] Re: S-100 Edge Footprint



See if these work Bob, otherewise I will look into it more.

John



On Wednesday, September 30, 2015 at 6:16:36 PM UTC-7, Bob Bell wrote:

S-100 gurus – especially those who use KiCAD:



I have been unsuccessful at locating a S-100 card edge footprint in the KiCAD (v4) built-in library. Do you have one you would share with me? As this is a rather critical part on the board, it would be great to find one that has been used successfully.



Thanks for your help.



Bob Bell